ID TECH Omni Manual de usuario descargar pdf (Pagina 43)

Set the Sequence in which Data Fields are Sent

This command speciﬁes the order in which data ﬁelds are transmitted to the

host. Each separate ﬁeld is assigned an upper case alpha letter in the order in

which it is created. So the ﬁrst data ﬁeld created is A, the second is B, and so

on.

SELECTION CODE: JK

Characters Assigned to Data Fields in the Transmission Order Desired

EXAMPLE:

To transmit ﬁelds A, B, and C to the host so that the second and third data

ﬁelds are reversed, enter:

... JK<ENTER>A<ENTER>C<ENTER>B<ENTER> ...

This means that data ﬁelds A, B, and C will be transmitted as A, C, and B.

Time Delay

In addition to specifying the order in which data ﬁelds are transmitted to the

host, you can add a time delay between each ﬁeld. The amount of time delay

is two digits multiplied by 100 milliseconds. So if the time delay speciﬁed is

“02” the time delay will be 200 milliseconds.

SELECTION CODE: JM

Two Digits for Time Delay

Delete One Formula

This command deletes a single formula stored in the reader’s memory. To do

this, you need to know the place the formula is stored in memory. In other

words, if the formula to be deleted is the third formula stored in the reader’s

memory, then you’ll need to enter the number 3.

SELECTION CODE: JS

One Digit to Indicate which Formula to Delete

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 68 69

Sin comentarios

ID TECH Omni Manual de usuario Pagina 43