ID TECH Omni Manual de usuario descargar pdf (Pagina 27)

Retail Bar Codes (Group G)

Retail bar codes are based on the Uniform Code Council product code encod-

ing algorithms. These are commonly referred to as the UPC/EAN symbolo-

gies.

1. Enter RETAIL BAR CODE SETUP MODE by typing /E/D/FG.

2. Press <ENTER>.

The reader should beep twice.

3. Type the two-character selection code for the bar code symbology you wish

to modify.

4. Press <ENTER>.

The reader should beep twice.

5. Type the one-character code for the change you wish to make.

6. Press <ENTER>.

The reader should beep twice.

7. Save the change and exit the Group Setup Mode by typing

GZ <ENTER>.

The reader should beep four times.

Note: To review the current setting(s), type GY<ENTER> while in Group Setup Mode.

To reset the current setting(s) to default, type GX<ENTER> while in Group Setup

Mode.

EXAMPLE:

To set the current settings to default, enter:

/E/D/FG<ENTER>GX<ENTER>GZ<ENTER>

UPC Settings:

Enable/Disable UPC-A

UPC-A is a ﬁ xed format symbology and there are no variations allowed. If

enabled, UPC-A symbology will be read, subject to the reading restrictions

speciﬁ ed by this set of options. If disabled, the data from the symbology will

be disregarded.

SELECTION CODE: G1

UPC-A Enable A

UPC-A Disable B

SELECTION CODE: G1

UPC-A Enable A

UPC-A Disable B

UPC-A Enable A

UPC-A Disable B

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 63 64

Sin comentarios

ID TECH Omni Manual de usuario Pagina 27