ID TECH Omni Manual de usuario descargar pdf (Pagina 14)

Bar Code Message Formatting Selections (Group C )

Scanned bar code data can be formatted with the addition of preambles,

postambles, and terminator characters. The settings below will augment bar

code data scanned by the Omni. A fully-formatted message block reﬂects the

following model:

{Preamble}{Code ID}{Data}{Terminator}{Postamble}

1. Enter BAR CODE MESSAGE FORMATTING SETUP MODE by typing

/E/D/FC.

2. Press <ENTER>. The reader should beep twice.

3. Type the two-character selection code for the feature you wish to change.

4. Press <ENTER>. The reader should beep twice.

5. Type the one-character code for the change you wish to make.

6. Press <ENTER>. The reader should beep twice.

7. Save the change and exit the Bar Code Setup Mode by typing CZ.

8. Press <ENTER>. The reader should beep four times.

Note: To review the group’s current setting(s), type CY<ENTER> while in the setup

mode. To reset the current setting(s) to its group default, type CX<ENTER> while in

Bar Code Setup Mode.

Bar Code Terminator Character

Enter and Line Feed, Enter, Line Feed, or None: For some applications, it

may be convenient to end a string of bar code scan data with a terminator

character. For example, with keyboard entry, it is common to have the opera-

tor signify the end of the data input with the “Enter” keystroke. The termina-

tor character serves this function.

SELECTION CODE: C1

RETURN and Line Feed A

RETURN B

Line Feed C

None D

EXAMPLE:

To set the bar code terminator character to Line Feed, enter:

/E/D/FC<ENTER>C1<ENTER>C<ENTER>CZ<ENTER>

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 68 69

Sin comentarios

ID TECH Omni Manual de usuario Pagina 14