ID TECH Omni Manual de usuario descargar pdf (Pagina 42)

Search for a Data String

This command allows you to create a data ﬁeld by searching the scanned data

for a data string that matches a data string speciﬁed in the formula. If a match

is found, the scanned data will be divided into three ﬁelds: the data from the

search start point to the character before the searched data string, the data

string itself, and the data remaining.

SELECTION CODE: JG

Characters that Constitute the Data String to be Searched for

EXAMPLE:

In scanned data, to search for the data string ABCDE, enter:

... JG<ENTER>A<ENTER>B<ENTER>C<ENTER>

D<ENTER>E<ENTER> ...

This means that scanned data “1234567ABCDEFG” will be divided into three

ﬁelds: 1234567 and ABCDE and FG.

Add a Data Field

This command allows you to add a character string to scanned data before

transmitting it to the host computer. The character string you add will be

transmitted as a separate data ﬁeld. (This command is optional.)

SELECTION CODE: JJ

Characters that Constitute the Data String to be Added

EXAMPLE:

In scanned data, to add one data ﬁeld “abcd” to the scanned data 1234, enter:

... JJ<ENTER>a<ENTER>b<ENTER>c<ENTER>d<ENTER> ...

This means that additional ﬁeld “abcd” can be added to output data string

abcd and 1234.

Note: The added string can be comprised of any characters from the full ASCII table.

However, the communication program used may not be able to accept the non-

printable characters.

Note: For CR, use CTRL-N (ASCII code 14h).

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 68 69

Sin comentarios

ID TECH Omni Manual de usuario Pagina 42