ID TECH Omni Manual de usuario descargar pdf (Pagina 48)

Section 5

OPERATION

Operating Procedure

The Omni reader is easy to operate. Just follow these simple steps:

1. Make sure the reader is properly connected (see sections 2 and 6) and is re-

ceiving sufﬁcient power. (See Section 6, Troubleshooting, if there is a cabling

or power problem.)

2. To read a card, slide the card, in either direction, through the reader slot,

with the bar code facing the optical head (LED side) or the magnetic stripe

facing the magnetic head (opposite side).

3. Once the entire bar code or magnetic stripe has been read, the LED

indicator will light up as green to signal a “good read.” If a good read is not

obtained, the LED indicator will light up as red.

4. A beep will also sound to indicate a good read on the bar code or each

magnetic track, as appropriate. If all three tracks have been read successfully,

the reader will beep three times.

5. The decoded data will be transmitted to the host application.

Note: Output data can be veriﬁed in Hyper Terminal (or another serial communication

program).

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 68 69

Sin comentarios

ID TECH Omni Manual de usuario Pagina 48